Pioneer LaserDisc Operation

TO PLAY A LASERDISC:

• Turn the TV monitor on
• Press the POWER button on the laserdisc player to turn the power on.
• Press the STOP/OPEN/CLOSE button so that the laserdisc player tray comes out.
• Put the laserdisc in the tray with the label facing upward.
• Press the STOP/OPEN/CLOSE button so that the laserdisc tray goes back inside the player.
• Press the PLAY button.

USING THE REMOTE CONTROL:

Chapter Search

• Hit CHAP/FRAME button until it says "Chapter" on the screen.
• Enter a chapter number and then hit the SEARCH button.

Frame Search

• Hit CHAP/FRAME button until it says "Frame" on the screen.
• Enter a frame number and then hit the SEARCH button.

Audio Tracks

• Press AUDIO to cycle through the different audio tracks (if available): (l/L=English, 2/R=Spanish, Digital Stereo=Both English and Spanish, Audio Off)

USING A BARCODER READER:

• Hold the barcode reader like a pencil (at about a 45 degree angle).
• Hold the READ button down and move the tip of the reader across the bar code.
• Be sure to move the reader quickly over the bar code. You may move the reader from left to right or right to left, but make sure that you move it across the entire barcode.
• You will hear a high beep if you read the barcode correctly and there will be a red light on the barcode reader.
• Point the barcode reader toward the videodisc player and hit the SEND button. Keep the reader pointed at the player until you hear a beep.

HOW TO PUT A LASERDISC AWAY

• Press the REJECT button to stop the laserdisc turning.
• Wait a few seconds for the laserdisc player to stop.
• Press the STOP/OPEN/CLOSE button so that the laserdisc tray pops out.
• Take the laserdisc out of the laserdisc player.
• Press the STOP/OPEN/CLOSE button so that the laserdisc tray goes back inside the player.
• Press the POWER button to turn the power off.